|
The second most important thing
needed to make henna is a slight acid. Lemon or lime juice will
do for this purpose. The most basic recipe is just to add henna
and lemon juice, but some prefer to use other ingredients. The
most common, and most effective of these is clove. Clove contains
a natural chemical that helps the henna make a deeper stain.
The easiest way to add clove to your recipe is to boil a handful
of whole cloves in lemon juice. Eventually the lemon juice will
be infused with the clove, and you can strain it and add it to
your henna.
Other ingredients which are
often used are a variety of essential oils. The most commonly
used is eucalyptus, but clove, camphor (white), lavender, lemon,
and other oils are also used. Most of these oils do nothing for
the henna but scent it, except Clove oil and Camphor oil, these
actually do boost the color. Clove oil acts the same way as the
lemon/clove infusion mentioned above, and camphor oil acts as
an oxidant. Both of these oils should be used with caution, as
they may be dangerous if used improperly. Clove oil can etch
metal, and will kill an exposed nerve, while camphor can be toxic
in large doses. No pure essential oil should be allowed to come
into contact with the skin unless it is diluted, usually with
a ratio of 1:10 in a carrier oil.
Making the henna paste
1) Measure into a bowl about one heaping tablespoon
of henna powder. Your henna powder should already be sifted,
if it needs it. See below for instructions and suggestions on
sifting.
2) Into the same bowl, add about 1/2 teaspoon of
sugar.
3) Now add the liquid. It should be strained, if
you are using fresh lemon juice or anything which may cause clogging.
Start by adding about one tablespoon, and stir it in little by
little to get the proper consistency. This is the hardest step,
because the consistency must be quite right to be able to use
it properly. It should be about like stirred yogurt, not so thin
that it drips, but not too thick either.
4) Give it a good stir, to make sure that the liquid
and henna are well mixed. Stir it vigorously for a few minutes,
to make sure that everything is properly incorporated. This should
remove most of the lumps, and the paste should be smooth and
green.
5) To transfer the paste to a plastic ziploc bag,
take a lump of it on the spoon, open the top of the bag, place
the spoon inside, and squish the henna downwards off of the spoon
with your fingers from the outside of the bag. If there is more
henna in the bowl, repeat this until it is all in the bag. Squish
the henna as far down into a corner as possible, and once the
air is compressed into the corner of the bag, slice a small bit
off of the corner, to let the air and henna out. Once you have
done this, you can begin to fill your empty applicator, in this
case a Jacquard bottle. Simply place the snipped corner of the
bag into the open mouth of the bottle and squeeze. A small line
of henna should drop to the bottom of the bottle, and begin to
fill it. Tap it on a tabletop every so often to make sure that
the henna has settled to the bottom. Then just snap on the top
of the bottle, screw on a stainless steel tip, and you are ready
to go!
Tips for drawing henna designs
The most important thing to
remember while hennaing is that if you make a grave mistake,
it can usually be fixed. This can be done with toothpicks, cotton
swabs, or simply by incorporating it into the design.
If you are decorating an entire
hand, start where you are most comfortable, depending on the
design. Common starting points are the line where the fingers
bend bordering the palm, the wrist, or the center of the palm.
It is usually easiest to begin by covering the palm, and then
doing the fingers. If you are right handed, start on the finger
that is the farthest to the left, and vice-versa if you are left
handed. This will make it possible for you to rest your hand
on the remaining fingers, without worrying about smearing the
freshly applied paste.
Copying henna designs- For many
beginners, the easiest way to draw a freehand design is to copy
it from either a lineart, other pattern book, or a henna design
that was done by somebody else. This makes it easier to fill
space and have the design come out neatly, because everything
is already mapped out. On the other hand, copying may prove harder,
if the design is too complex for the beginner's ability.
Improvising henna designs- It
is challenging at first to improvise henna
designs, but once you build up a 'design vocabulary' from the
different design styles and traditions, it becomes natural. By
a `design vocabulary' I mean a basic knowledge of the shapes,
borders, and types of patterns used in henna. For instance, once
you become familiar with the Moroccan style, which uses triangles,
diamonds, zig-zags, and other geometric shapes, it will be easy
for you to make up a design in that particular style.
To ease the transition from
copying to improvising, it works well to first get a firm ground
in the actual technique by copying, and then, as you move on,
try copying a design, but changing some small part of it. Once
you are used to tailoring and changing designs to your own taste,
it will come easily to make up a design in the same way.
Important Note: You should NEVER
use BLACK HENNA. A chemical called PPD, present in black henna,
can cause chemical burns on your skin. |
Refer
